Engine mount spacer

[Emlupi]

Good afternoon,
I am missing this part from my ‘73 CL350. It is pretty much unavailable everywhere. Was wondering if someone could provide the dimensions of this spacer so I can try and find an alternative or fabricate a replacement. Many thanks.

 

[RobMan]

Do you have the part number? Sometimes other people can find stuff on line we miss.

 

[ancientdad]

Do you have the part number? Sometimes other people can find stuff on line we miss.

I just checked the usual suspects including David Silver, nothing.

Part number 50329-286-010

Shouldn't be too difficult to find something suitable for it though, it's not anything exotic.

 

[ballbearian]

50329-286-010 up to K4, for sure. I'll go measure my loose basket case one (K2) and try to check length on my 73 CL350.

EDIT: Wouldn't cha know. It's missing. Anyway, it's 12.5mm long and 24mm outer dia. with a 10mm bolt.

 

[ancientdad]

50329-286-010 up to K4, for sure.

I checked a K3 listing, I don't think it changed for the CB and CL to the end of production, frames and mounts were the same.

 

[RobMan]

I have just used a stack of flat washers when a spacer has gone missing on a project. Not right but will work until you come up with the right one. I usually have to use a combination of thick and thin washers to make it fit the space.

 

[ballbearian]

I checked a K3 listing, I don't think it changed for the CB and CL to the end of production, frames and mounts were the same.

Yep, samo. I checked the 3 bikes here, 73CB, 73CL and 68K0.

24mmm outer, 10+ inner, 12.5mm length.

 

[Boomer343]

I always use a empty crankcase bottom to check the fit of that spacer as it often shows up the lower frame rail having been pulled in when someone bolted up the engine without the spacer.

Easy to get it to fit with a scissor jack and a few blocks of wood.

 

[Emlupi]

Many thanks all. If I can’t find one I will make something to fit.
Is it made of steel or aluminum? I assume it’s made of steel.

 

[ausman1000]

Yours for free if you can send me a shipping label.

Comes in at 3.2 oz for the ensamble.

 

[Emlupi]

Thanks plenty, definitely can do. You can PM me the address and I will take care of it.

 

[ausman1000]

Thanks plenty, definitely can do. You can PM me the address and I will take care of it.

PM sent

 

[EzPete]

The eBay store of unobtainable parts this forum could put together would be impressive, albeit not very profitable!

 

[Emlupi]

Some days I swear I could ruin an anvil with a rubber mallet.
I was digging around in a box of spares that came with my bike and, lo and behold, lookie here what I found.
Well, I guess now I have two.

 

[ausman1000]

yes you do

 

[LongDistanceRider]

Save it and label it, someone will need it.