CB450K series conrod dimensions

[Santiago]

Hi, wondering if anyone out there has a dis-assembled crank shaft and may be able to measure the dimensions of the con rod please, in In or mm, doesn't matter, I really need the ID of the big end and the centre to centre measurement.

Picture for attention.

 

[ancientdad]

Assuming you're speaking of a rod from a DOHC 450, you will find a few members in this thread who can answer that for you.

Crankshaft Cleaning

If you can afford a 20t press and a few scraps of metal, it is a straightforward process to pull early Honda cranks apart and do it properly. The big-end pin sludge trap is the most critical as when it blocks it cuts off the cooling/lubricating supply to the cylinder wall and small end.

www.vintagehondatwins.com

 

[Santiago]

Assuming you're speaking of a rod from a DOHC 450, you will find a few members in this thread who can answer that for you.

Crankshaft Cleaning

If you can afford a 20t press and a few scraps of metal, it is a straightforward process to pull early Honda cranks apart and do it properly. The big-end pin sludge trap is the most critical as when it blocks it cuts off the cooling/lubricating supply to the cylinder wall and small end.

www.vintagehondatwins.com

Thanks, yes, DOHC, I'll have a read through that thread and post the question there. Cheers